New MakerJuice SF Resin

You can discuss Photo-sensitive resins, polymers, and oligomers.
AndersonTa
Posts: 189
Joined: Mon Dec 09, 2013 4:28 pm
Location: Houston, TX
Contact:

New MakerJuice SF Resin

Postby AndersonTa » Sat Apr 19, 2014 10:11 pm

http://makerjuice.com/2014/04/19/new-re ... r-support/

New SubSF (SF= Snap-fit) resin from MakerJuice...and Form1 compatibility!
@AndersonHTa

BMMal
Posts: 17
Joined: Wed Jun 18, 2014 8:49 am

Re: New MakerJuice SF Resin

Postby BMMal » Tue Aug 12, 2014 6:43 pm

What are people using for cure times with this resin? I have a 2200 lumen projector at .1mm xy at 140mm x 105mm. That means I have about 15 lumens/cm^2.

For SF at 50 microns I have to use a 10 second cure time, which seems to be causing banding around my part...

I am testing 15 microns right now but it seems that 5.5 seconds is enough time to cure it now...

I also noticed that my parts are oblong. I printed a circular cap at a 45 degree angle with the opening up. When it finished it was very oval.

Any ideas?

I'm using a flex bottom vat by the way. The next time I clean it and switch resin I will take pictures of it and post them.


Return to “Resins”

Who is online

Users browsing this forum: No registered users and 2 guests