Sanyo z3
Posted: Sat Feb 11, 2017 2:26 am
Hi,
I have a Sanyo Z3 projector, and am trying to mod it for SLA printing.
At this point, I have removed the UV filter (part L14 in the attached picture). Should I remove the polarizers also? They are parts L16,L17, and L18 in the diagram. I also read that there is a second UV filter but am not sure where it is. Any insight would be greatly appreciated, as without part L14, I still cannot get the resin to cure. Am I missing something? Thanks in advance!
I have a Sanyo Z3 projector, and am trying to mod it for SLA printing.
At this point, I have removed the UV filter (part L14 in the attached picture). Should I remove the polarizers also? They are parts L16,L17, and L18 in the diagram. I also read that there is a second UV filter but am not sure where it is. Any insight would be greatly appreciated, as without part L14, I still cannot get the resin to cure. Am I missing something? Thanks in advance!