Projector characteristics
Posted: Sun Mar 30, 2014 7:37 pm
Hi people,
I'm new and I'm trying to make a 3D printer and I've got few questions about the projector, maybe you can help me.
- The resine is cured thanks to the UV light? there are resines that works without UV light? differences between them?
- The only important characteristics in a projector are: resolution and lummens?
- All the projectors produce UV light? Only I have to remove the filters like the colour wheel?
- The cure speed depends of the lummens quantity? more lummens less seconds?
- I've seen a lot of people using the Acer H6510BD, it's so expensive but it doesn't need any mod. So, do you recommend it? exists a cheaper alternative?
Thanks!
I'm new and I'm trying to make a 3D printer and I've got few questions about the projector, maybe you can help me.
- The resine is cured thanks to the UV light? there are resines that works without UV light? differences between them?
- The only important characteristics in a projector are: resolution and lummens?
- All the projectors produce UV light? Only I have to remove the filters like the colour wheel?
- The cure speed depends of the lummens quantity? more lummens less seconds?
- I've seen a lot of people using the Acer H6510BD, it's so expensive but it doesn't need any mod. So, do you recommend it? exists a cheaper alternative?
Thanks!