Any Problems With My Design?
Posted: Sun May 22, 2016 9:59 pm
Hello,
I am not new to 3D printing, I built a Prusa i3 as my second printer and have loved that so far, but I want more precision. I used the extrusion models from OpenBuilds to create my own SLA printer design in Sketchup, I have attached the pictures below. Some things I want to know: I will be using 0.7mm glass for the bottom basin, to make the device more modular, I want to have that basin slid in and out so I can replace it with a smaller one for less wasted resin. Is there a better way of doing it than I have in my model using the extrusions? Another thing, I have see so many different designs and some have tilting basins and some don't, would you recommend one or not?
Thanks,
Mason
I am not new to 3D printing, I built a Prusa i3 as my second printer and have loved that so far, but I want more precision. I used the extrusion models from OpenBuilds to create my own SLA printer design in Sketchup, I have attached the pictures below. Some things I want to know: I will be using 0.7mm glass for the bottom basin, to make the device more modular, I want to have that basin slid in and out so I can replace it with a smaller one for less wasted resin. Is there a better way of doing it than I have in my model using the extrusions? Another thing, I have see so many different designs and some have tilting basins and some don't, would you recommend one or not?
Thanks,
Mason