Littlerp for jewellery casting advice
Posted: Sat Apr 30, 2016 2:49 am
Hello
I am looking at buying the Littlerp to make models for jewellery casting in silver. I have a few questions:
1) is it good enough to create enough detail
2) I've seen a lot of pictures where the design has little branches coming off of it- I'm assuming that has to be worked into the design when printing for use in casting- how would I know where to put them?
3) what's the best resin stuff to use?
I've seen people talk about burn out and other bits and haven't got a clue what they mean! I'm a complete newbie and know virtually nothing about 3D printing!
I am looking at buying the Littlerp to make models for jewellery casting in silver. I have a few questions:
1) is it good enough to create enough detail
2) I've seen a lot of pictures where the design has little branches coming off of it- I'm assuming that has to be worked into the design when printing for use in casting- how would I know where to put them?
3) what's the best resin stuff to use?
I've seen people talk about burn out and other bits and haven't got a clue what they mean! I'm a complete newbie and know virtually nothing about 3D printing!