Is there a FAQ about best practices for what to do with your resin print after you pull it from the printer? Brief wash in IPA? Long soak in IPA? Post cure in the sun?
My prints are nice, but a little bit sticky. Not sure what the next step is.
Thanks!
Jon
best practices for processing a print after it leaves the printer
Re: best practices for processing a print after it leaves the printer
Is it possible to reset your printer and make the printing not so sticky? I think this will be a better alternative.
Last edited by AdaBrown on Wed Aug 05, 2015 6:03 am, edited 1 time in total.
BOC Sciences Inhibitor