best practices for processing a print after it leaves the printer

General discussion of topics that don't seem to fit anywhere else.
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
jon_bondy
Posts: 78
Joined: Tue Jun 16, 2015 10:55 pm
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

best practices for processing a print after it leaves the printer

Postby jon_bondy » Mon Jul 27, 2015 8:43 am

Is there a FAQ about best practices for what to do with your resin print after you pull it from the printer? Brief wash in IPA? Long soak in IPA? Post cure in the sun?

My prints are nice, but a little bit sticky. Not sure what the next step is.

Thanks!

Jon

AdaBrown
Posts: 2
Joined: Wed Aug 05, 2015 5:50 am
Contact:

Re: best practices for processing a print after it leaves the printer

Postby AdaBrown » Wed Aug 05, 2015 6:01 am

Is it possible to reset your printer and make the printing not so sticky? I think this will be a better alternative.
Last edited by AdaBrown on Wed Aug 05, 2015 6:03 am, edited 1 time in total.
BOC Sciences Inhibitor


[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable