Help troubleshooting my prints

General discussion of topics that don't seem to fit anywhere else.
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
etxbkst
Posts: 1
Joined: Fri Jun 26, 2015 7:41 am
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Help troubleshooting my prints

Postby etxbkst » Fri Jun 26, 2015 7:48 am

I just built a dlp top down, and all of my calibration cubes are turning out like the attached photo. I'm using makerjuice g+, a Mitsubishi xd221u projector. 8 sec per layer, 16 sec for bottom layers. I'm using grbl for my moton control.

Thanks!
Attachments
rNfLH9J.jpg
vWvhRaC.jpg
JOP02Z6.jpg

android78
Posts: 41
Joined: Sun May 18, 2014 10:33 pm
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Re: Help troubleshooting my prints

Postby android78 » Fri Jun 26, 2015 7:56 pm

How much settling time do you have between layers? Have you tried increasing it? Do you have any video of it printing?


[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable