[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 574: sizeof(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 630: sizeof(): Parameter must be an array or an object that implements Countable
Build Your Own SLA/SLS • Help troubleshooting my prints
Page 1 of 1

Help troubleshooting my prints

Posted: Fri Jun 26, 2015 7:48 am
by etxbkst
I just built a dlp top down, and all of my calibration cubes are turning out like the attached photo. I'm using makerjuice g+, a Mitsubishi xd221u projector. 8 sec per layer, 16 sec for bottom layers. I'm using grbl for my moton control.

Thanks!

Re: Help troubleshooting my prints

Posted: Fri Jun 26, 2015 7:56 pm
by android78
How much settling time do you have between layers? Have you tried increasing it? Do you have any video of it printing?