SLA printing

General discussion of topics that don't seem to fit anywhere else.
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
avinash3333bhat
Posts: 12
Joined: Mon Jun 08, 2015 1:45 pm
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

SLA printing

Postby avinash3333bhat » Mon Jun 08, 2015 1:59 pm

Hi people,
I have built an FDM 3d printer but SLA is kinda new for me. Where do I get started for building one? like the mechanism used, all the calculations etc etc.
I do plan on building a good one for engineering purpose although I'm kinda lost on where to start (unlike open source fdm printing).
Any kind of information would be great!!!

sodium
Posts: 159
Joined: Thu Jan 01, 2015 2:56 pm
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Re: SLA printing

Postby sodium » Mon Jun 08, 2015 5:41 pm



this is a good place to start

Hugues
Posts: 82
Joined: Thu Oct 02, 2014 3:20 pm
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Re: SLA printing

Postby Hugues » Tue Jun 09, 2015 1:11 am

Parts printed with current resin technology are not strong enough for engineering purpose though.

avinash3333bhat
Posts: 12
Joined: Mon Jun 08, 2015 1:45 pm
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Re: SLA printing

Postby avinash3333bhat » Wed Jun 10, 2015 11:15 am

I have been going through some basics. I have some questions:
1. The frame: any advice on cheap and best buys.. i was thinking of Alu extrusions. But since there will be less moving components can I go with any other cheaper material?
2. The linear actuactor for vertical motion: Any ideas here again? THK KR26 looks like a good option. But if you guys have any ideas I can work on it. :)


[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable