[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 574: sizeof(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 630: sizeof(): Parameter must be an array or an object that implements Countable
Build Your Own SLA/SLS • Water beading issue on resin surface
Page 1 of 1

Water beading issue on resin surface

Posted: Tue Dec 23, 2014 2:40 pm
by Cosmo
Hi everyone,

I'm having an issue with my top down set up floating funtodo resin on top of salt water. After a few uses I am getting little bubbles of water floating up to the top of my resin. This is driving me crazy because I'm not sure why it is happening and it is causing major issues during prints. Has anyone had this experience?

Re: Water beading issue on resin surface

Posted: Tue Dec 23, 2014 2:58 pm
by cncbasher
it's probable your salt to water ratio is not enough , or that your water is contaminated , especially if you have used a different resin in the same tank before
make sure the tank is clean using Isopropyl alcohol and make sure the tank is dry , try fresh de-ionised water and fresh salts .
if the salt has been left in an open container before use , it is possible to pick up contaminants , including from your hands , so wear gloves .