I'm trying to get a general top-level understanding of which parts are responsible for what. I know from fooling around with Marlin that it defines axis lengths, steps/mm, motor speeds, and a host of possible peripherals.
The CW software then slices the object, renders the G-Code and communicates that to the board, so the Firmware must also interpret the commands from the software, or am I off the mark?
Relationship between firmware and software
-
telephone1652
- Posts: 10
- Joined: Sat Nov 01, 2014 12:57 pm [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
-
telephone1652
- Posts: 10
- Joined: Sat Nov 01, 2014 12:57 pm [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable