Smooth surface pan paper

General discussion of topics that don't seem to fit anywhere else.
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
pointless_cog
Posts: 1
Joined: Sun May 18, 2014 6:22 am
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Smooth surface pan paper

Postby pointless_cog » Sun May 18, 2014 6:32 am

Hi all,

New to the forum and SLA 3d printing. Have been churning through the posts over the weekend sucking up as much info as possible! So to my question, in the FAQ post:

viewtopic.php?f=11&t=17

A paper (Pan, 2011) is linked to describing a technique to achieve smooth surfaces using a greyscale effect on the slices and also using the surface tension of the resin. I was wondering if this technique is actually used by anyone? Has anyone got any experience with it and does it truly improve performance?

Cheers,
Ben

[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable