Build Your Own SLA/SLS

i can't see anything new about it , so i'd say it's just someone on the bandwagon re-inventing the wheel .
however i dont mind being proven wrong , as this world needs more creative minds

Andy, first my apology ! , i must have been half brain dead last night , looking at different angles haha you would seem to be only working correctly or at least near enough with the lower galvo ( first mirror ) the second galvo is either been over driven or just not driven , just do nothing else th...

Cncbasher Believe that the driver of stepper motor are not the problem, because they usually funcinam with another program. I hope you have patience with our language, because here is from Brazil and our English is not so good. no problem at all , do not worry .. if the lights do not flash , their ...

can you detail the changes you made to the arduino code and the settings of the dip switches of the stepper driver you can check if the board is at least communicating correctly by opening the arduino terminal setting to the com port to use and baud of 115200 in the send box put : <INIT###'#'# then ...

nice job Sam

Hi you appear not to have your laser set correctly , your orientation is incorrect the laser should hit the first lower mirror at an angle of 45 deg and it then go's in a vertical then the laser bounces off second mirror at 45 deg , and the resultant beam then on to the target see attached pics , th...

iv'e checked the code you linked to and it works fine here .
let me know of any changes you made to the code , setup values etc
and details of your interface . the interface as shown in the link , does work exactly as posted


Dave

Hello .
contact me off list , to save running a large thread , and i'll help sort it out
if you have skype give me a call

Dave

is the source for the laser plugin going to be available ?

sillybird: what problems errors do you have ?