Build Your Own SLA/SLS

It works now! I disabled temperature sensors.

#define TEMP_SENSOR_0 0 // 0 instead of 1!!

#define TEMP_SENSOR_1 0

#define TEMP_SENSOR_2 0

#define TEMP_SENSOR_BED 1

Is it possible to run Marlin firmware without endstops? At the moment I have working setup with Sprinter but I would like to add servo shutter so I guess I need Marlin. But I just can't make it work....

Hi people, At the moment I could get some 0.05mm FEP foil leftovers. But still I have to take all of them so that is like 20m2... Is anyone here interested? Price would be around 50€/m2 + shipping. It is from 1,2m roll. I am from Europe but I have no problem sending to other countries. If there is e...

If you are using modified ATX you need continuous load. In order to fix that people wire 10 Ohm 10W power resistor (or something close of that) that acts as continuous load. This might be your problem... Otherwise I am having the same problems with speed and time calculation. If anyone have an idea ...

Hi. I have problem with connecting my Chinese Ramps 1.4 and Raspberry pi. I have installed CW Host as written on Github, Ramps 1.4 works (I checked with test code if stepper spins). But when I try to connect from PC browser it shows me CW Host interface but I can't do anything. "Problem communi...

Thank a lot

Or if anyone else could upload configured Merlin/Sprinter firmware which works with CW? Thank you in advance.

Uploaded this to DB for anyone that is wanting to use Marlin on there DLP build with CW. It is setup to use a hobby servo off of pin D11 You will need to change the max travel limits after homing to fit your build, this uses one end stop for the Z and software limited for the height. End stops will...

Hi. In CW is it possible to setup custom resolution in order to export PNG slices for projector that is not connected to the CW? Because at the moment I am testing my DLP and I would like to simply project pictures using Powerpoint...

Thank you very much