as this is meant fro a Pi then the underlying code is Linux . so probably would take some refactoring to run on windows etc
is everyone using windows . and a Pi , seems to be a few options floating around , whats needed ? , where's the gap that needs filling etc
Search found 54 matches
- Mon Nov 10, 2014 8:36 am
- Forum: Creation Workshop
- Topic: New Creation Workshop RPi Host
- Replies: 36
- Views: 116916
- Sat Nov 08, 2014 9:16 am
- Forum: Hardware
- Topic: Nema 17 slipping
- Replies: 4
- Views: 12711
Re: Nema 17 slipping
stepper motors slipping or not moving or irratic etc , is mostly down to either trying to run the stepper at a higher speed than it's capable of this can manifest it's self in many ways . such as low voltage , not enough current , incorrect setup between what you have the stepper driver set for and ...
- Fri Nov 07, 2014 11:24 am
- Forum: Electronics
- Topic: How to wire a 3 phase stepper to ramps
- Replies: 1
- Views: 10626
Re: How to wire a 3 phase stepper to ramps
no is the simple answer , not without firstly changing the stepper drivers , and then modifying marlin or whatever software your looking at using there are 3 phase stepper driver chips available for example sanyo STK673-010 ,these use the same step/direction input so may be an option , depends if yo...
- Sun Nov 02, 2014 10:21 am
- Forum: General
- Topic: lcd3dprinter
- Replies: 27
- Views: 116860
Re: lcd3dprinter
sounds to me a company that files patents , then waits for others to develop , and then they snaffle it under patent as everyone seems to be doing these days
vapourware comes to mind
however i'm an engineer so everything is possible , unless proven wrong
vapourware comes to mind
however i'm an engineer so everything is possible , unless proven wrong