Search found 5 matches
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable- Wed Mar 11, 2015 5:45 am
- Forum: Software Forum
- Topic: Print problem
- Replies: 7
- Views: 17615
Re: Print problem
Update: after i followed every command sent by CW to board, i observed that CW sent G1 Z5, to lift, and after that G1 Z -4.5, to set the height for the new slice, the build platform came in the same position like it was sending G1 Z-5. after more tinkering and reuploaded the firmware 3 time with no ...
- Mon Mar 09, 2015 5:44 am
- Forum: Software Forum
- Topic: Print problem
- Replies: 7
- Views: 17615
Re: Print problem
from control cw z axis goes full 200mm. i change it to 400, and stil its limited to 10mm. how can i change from CW relative positioning to absolute: ;********** Lift Sequence ******** <DELAY> 1000 G1 Z($ZLiftDist * $ZDir) F$ZLiftRate G1 Z(($LayerThickness-$ZLiftDist) * $ZDir) F$ZRetractRate ;<Delay>...
- Mon Mar 09, 2015 3:12 am
- Forum: Software Forum
- Topic: Print problem
- Replies: 7
- Views: 17615
- Sun Mar 08, 2015 8:54 am
- Forum: Software Forum
- Topic: Print problem
- Replies: 7
- Views: 17615
Re: Print problem
I use Marlin,
i will check it out.
i will check it out.
- Sun Mar 08, 2015 8:21 am
- Forum: Software Forum
- Topic: Print problem
- Replies: 7
- Views: 17615
Print problem
Hi guys, Congratulations for the great job you are doing here. so, my problem is that on every print after 10 mm the z axis stops to rize, the print wont get bigger than 10 mm. the z axis will still do all the movements necessary to print but will not get bigger than 10 mm. any suggestions? the prin...
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable