(Steps per millimeter - leadscrew driven systems)
Search found 37 matches
- Wed Mar 04, 2015 6:57 am
- Forum: Vat Design and Construction
- Topic: Flex bottom VAT
- Replies: 70
- Views: 81192
Wow your vat looks incredible! Try holes in the build platform and/or some thin acrylic under the FEP to prevent sagging in the middle. Also higher exposure times for the first couple of layers and you also can sand your build platform (to make it more sticky). Hope that helps, Matthias
- Mon Mar 02, 2015 2:05 am
- Forum: General
- Topic: Printer and Projector are out of Sync, help please SOS
- Replies: 2
- Views: 3654
My first guess would be that your lift sequence does take a lot longer than 2000ms. Try a higher value.Did you use the auto-calc button? If that's the case you should check your firmware stettings. Don't know much about grbl, but there should be a setting for max z speed. Hope that helps...
- Thu Feb 19, 2015 8:43 am
- Forum: Hardware showcase / Build Logs
- Topic: DIY, Post-curing oven
- Replies: 3
- Views: 5654
Just finished building a cheap UV-curing oven: IMG-20150219-WA0001.jpg LEDs 43,00€, 410nm: http://www.amazon.de/gp/product/B00NV2CP48?psc=1&redirect=true&ref_=oh_aui_detailpage_o01_s00 Bin 15,25€, d=350mm, h=400mm: http://www.ebay.de/itm/301164618588?_trksid=p2060778.m2749.l2649&var=6002...
- Sat Feb 07, 2015 4:39 pm
- Forum: Electronics
- Topic: Cheapest board for a DLP printer?
- Replies: 5
- Views: 7785
Hi everybody, since I'm not very experienced in electronics I wanted to ask what the cheapest alternative for an Arduino Mega + Ramps + Motor driver would be (~30€ in Germany). Since I only plugged two z-steppers and one servo (and one endstop) my Ramps seems to be a bit overdone. I found this list ...