Build Your Own SLA/SLS

Try higher exposure times (assuming you're on 50 micron layers). You still look a little undercured (to my rookie eyes lol). I had to go up to around 4500-5000 ms to get my Makerjuice to reliably print supports! Out of curiosity what projector are you using? I'm pretty new to all of this - but I wo...

http://i603.photobucket.com/albums/tt117/deadmeat30/Black%20Dragon%20Castings/printing/IMG_20150110_205153_zpsvosiqhdb.jpg Wow! That turned out much better than my first print. What resin did you use. I opted to get the MadeSolid resin with the printer, but I just got a big box of Makerjuice to try...

I was just finishing up another test print when I saw your post. I did the math - but like a bonehead I did it backwards. lol Oh well. I used the new print as a basis - did the math on it, double checked it with the first print and my initial settings and it comes out really close. Tomorrow morning ...

Also, any recommendations to help me improve my prints would be very welcome. I assume that since the smaller holes are closed up that means I have bleed through on this resin and I need to drop the cure time a little bit??

I have recieved my LittleRP Kickstarter printer and have it fully assembled and JUST printed out my first print. YAY!! Anyway - I printed the calibration target block with the numbers and letters inset into it with the ramp. I measure the length of it and it comes in at 1.108" - if I am right t...