Search found 6 matches
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable- Tue Dec 23, 2014 1:12 am
- Forum: LittleRP
- Topic: Anti-backlash nut
- Replies: 4
- Views: 9880
Re: Anti-backlash nut
Thanks for the picture. I backed out the screw, and reseated it, and it found a better home. I found that holding in the nut on the tip of the screw when turning the screw counter-clockwise helped, and it clicked a tiny bit, then the screw was set into the brass body, not sticking out as before. I m...
- Mon Dec 22, 2014 12:51 am
- Forum: LittleRP
- Topic: Anti-backlash nut
- Replies: 4
- Views: 9880
Re: Anti-backlash nut
The attached image shows what it looks like, with a flashlight lighting from behind.
I've tried to push and pull the threaded rod along its axis and I don't feel any wiggle, so I'll assume that the nut is doing its job, unless there's a better way to test it.
Thanks.
I've tried to push and pull the threaded rod along its axis and I don't feel any wiggle, so I'll assume that the nut is doing its job, unless there's a better way to test it.
Thanks.
- Sun Dec 21, 2014 5:03 pm
- Forum: LittleRP
- Topic: Anti-backlash nut
- Replies: 4
- Views: 9880
Anti-backlash nut
I've pushed the anti-backlash nut into the body against the spring and according to the directions, it should "be sunken into the anti-backlash nut body at least 2mm or so," but in my case the nut seems to be protruding out of the brass body by about 2mm. I've tried to press the nut furthe...
- Sun Dec 21, 2014 12:30 am
- Forum: LittleRP
- Topic: Mounting electronics on the rear panel
- Replies: 2
- Views: 6591
Re: Mounting electronics on the rear panel
Ah, that helps.
Now I also see that I need a few more washers and nuts, so off to the hardware store tomorrow!
Thank you!
Now I also see that I need a few more washers and nuts, so off to the hardware store tomorrow!
Thank you!
- Sat Dec 20, 2014 6:50 pm
- Forum: LittleRP
- Topic: Mounting electronics on the rear panel
- Replies: 2
- Views: 6591
Mounting electronics on the rear panel
Hello, I received my kit last night and just started assembly. The step-by-step instructions ( http://imgur.com/a/fgDPR ) are very helpful. The rear panel I have looks different than the one shown in the step where the (6) M5x12mm buttonheads and T-slot nuts are are added. I have two smaller offset ...
- Thu Jul 03, 2014 11:16 am
- Forum: Vat Design and Construction
- Topic: Vibrating reservoir to eliminate sticking?
- Replies: 0
- Views: 8472
Vibrating reservoir to eliminate sticking?
I wonder if anyone has tried attaching a vibrating motor or piezo buzzer to a reservoir/vat so that cured resin would not have a stable place to stick to. Would this eliminate the need to peel each layer from the vat?
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable