I use creation workshop to generate the PNG's, if you have a miicraft you have to make the idx file by hand. its an ascii file and easy to read.
hp
Statistics: Posted by hp_ — Wed May 07, 2014 9:44 am
]]>
As you know , the file which writes in python implements of low efficiency, so i use Creation Workshop instead. But the sliced png images generate by Creation Workshop don't work on my machine. And i don't know why.
Can Creation Workshop slices the STL file to a svg file or files? Or maybe there are other problems in it?
If you have other slice software for DLP printer, i hope you can tell me, thank you !
Looking forward to your reply!
snowzk
Statistics: Posted by snowzk1990 — Wed May 07, 2014 9:12 am
]]>
In the CW5 I reached into G-code. For the Tilt (extra) more speed in a row. The result was chaos on the Arduino Out. With the ZIP backup also was the problem. Previous versions are going well.
Statistics: Posted by Barthadesign — Tue Apr 15, 2014 7:57 pm
]]>
Only thing that I would really like out of this software if it's possible is to be able to save off the STL file with supports/plated ready to go. I have my printer in the garage so it would be great to be able to build everything on my main PC then just load the file and slice on the laptop connected to the printer.
Thanks for all your hard work on this Steve.
Clinton
Statistics: Posted by Finhead — Fri Apr 04, 2014 1:49 pm
]]>
Statistics: Posted by Finhead — Tue Mar 25, 2014 9:47 pm
]]>
]]>
]]>
]]>
]]>
]]>
]]>
]]>
]]>
]]>
]]>