Just put the right amount of delay and sequence looks good!
Still have yet to try the B9 yellow. Hope this works!
Thanks again for your help Mattasmack.
Statistics: Posted by hirenashra — Wed May 25, 2016 10:02 am
]]>
If you've edited the gcode manually, the 'lift and sequence time' box on the slicing profile options tab matches the $BlankTime parameter on the gcode tab. (Make sure you haven't deleted the " ;<Delay> $BlankTime " line or, if you have, make sure you have your own delay command that gives the necessary delay.)
If you're using other software I don't have a specific recommendation, but somewhere there should be a delay parameter that you have to increase.
Statistics: Posted by Mattasmack — Tue May 17, 2016 8:50 pm
]]>
]]>
]]>
]]>
]]>
]]>