From the PDF it looks like your KK50 has a lead of 2mm (if your model number is actually a KK-50-2). You can also measure this on your screw. Microstepping is set by your jumpers on your board (1/16 =all jumpers installed ). I need to revise my formula to:
mm_per_steps = 1 / ((motor_steps_per_rev * driver_microstep) / thread_lead)
So using the information you gave us:
mm_per_steps = 1 / ((200 * 16) / 2) = 0.000625mm [somebody please check my math]Statistics: Posted by dangre — Wed Dec 02, 2015 2:05 pm
]]>