As a test, I'm putting a drop of resin on my build platform and waiting for it to cure with the projector at full blast white, on the bright setting (308W). I've left it for over a minute and it's still soft. If I hold the drops a few inches away from the projector, they will cure in a few seconds, but the projector can't focus that close.
From the build plate to the projector is about 10" with a 45* front surface mirror. Top down build.
The projector is an Optoma HD2200.
Am I doing something wrong or is the projector just not putting out enough UV?
Thanks,
VaughanStatistics: Posted by kakapoopie — Tue Jul 08, 2014 7:31 pm
]]>