]]>
]]>
]]>
]]>
]]>
dvd motor spec ( resonably standard )
pl15s020.pdf https://github.com/taksan/Arduino-Lab/b ... 15S020.pdf
the problem you will have is that the tb6560 , suit 1.8 deg steppers , where dvd steppers are 18 deg per step
so they probably will not be optimum .
you'll find full step is better for these drives , however i do not think the tb6560 goes to full step , i think the lowest is half step
so probably a basic L298 Circuit may be better , i dont know .
Statistics: Posted by cncbasher — Thu Jan 01, 2015 9:15 am
]]>
]]>
]]>
25mm high with 50µm / layer (max resolution limit of the DVD reader).
Statistics: Posted by FR3Dprint — Wed Dec 31, 2014 2:20 pm
]]>
Statistics: Posted by FR3Dprint — Mon Dec 29, 2014 12:11 pm
]]>
the video can be seen on the FB page.
actually, the miror is a hdd and not a cd. optical miror are expensive and hard to find.... while a old hdd... there are tons around u ! the quality is fine and I see no difference with optical miror for printing. (I'd tested both).
Statistics: Posted by FR3Dprint — Tue Dec 23, 2014 1:38 am
]]>
]]>
]]>
Statistics: Posted by FR3Dprint — Mon Dec 22, 2014 3:42 pm
]]>